Goldline AQL-PS-4 User Manual download pdf (Page 44)

Chlorination

With the use of the optional AQL-CL chlorination kit, the Aqua Logic is also an automatic chlorine genera-

tion system for pool and/or spa sanitization. If enabled (see Configuration Menu), this operation requires

a low concentration of salt (sodium chloride) in the pool/spa water. The Aqua Logic automatically con-

verts the salt into free chlorine which kills bacteria and algae in the pool/spa. Chlorine will revert back to

sodium chloride after killing bacteria. These reactions will continuously recycle, virtually eliminating the

need to add sanitizing chemicals to your pool/spa. The only time you may need to add more salt to the

pool/spa is when water is replenished due to backwashing, draining, or splashing (not evaporation).

The Aqua Logic is designed to handle the purification needs of most residential swimming pools up to

40,000 gallons (150,000 liters), or the needs of most commercial pools up to 25,000 gallons (95,000

liters). Check local codes for other restrictions. The actual amount of chlorination required to properly

sanitize a pool varies due to bather load, rainfall, temperature, and the pool’s cleanliness.

For pools larger than 40,000 gallons, the Aqua Logic can control one or more Goldline Aqua Rite chlori-

nators to supplement chlorine production.

NOTE: Before installing this product as part of a saline water purification system in a pool or spa using

natural stone for coping or for immediately adjacent patios/decking, a qualified stone installation specialist

should be consulted regarding the appropriate type, installation, sealant (if any) and maintenance of stone

used around a saline pool with electronic chlorine generator in your particular location and circumstances.

Default Display

Turn power on at the main panel and turn the Aqua Logic control power circuit breaker on. The keypad

will show the default display. The default display alternates between the day/time, air and pool (or spa)

temperature, pool/spa sanitizer setting, and salt level. Under certain circumstances, additional displays

may be added to the default menu to inform you about system operation. Refer to the Programming Menu

Flowchart on page 7 to view all possible displays. The Aqua Logic will automatically scroll through all of

the available default menu displays or you can press “<” or “>” to manually scroll.

Optional Remote Display/keypad shown--the display keypad on the

main control unit will have a “Service” button in the upper left

corner instead of the “System Off” button.

The following statement is applicable if any of the wireless accessories are connected to the Aqua Logic

system.

FCC Statement

(Compliance Statement, Part 15.19): This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

WARNING (Part 15.21): Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment.

Industry Canada Statement

The term “IC” before the certification/registration number only signifies that the Industry Canada technical

specifications were met.

Interference

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, then the user is encouraged to try to correct the interfer-

ence by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into a power source on different circuit than the receiver.

• Consult the dealer or an experienced radio/TV technician for help.

1 2 ... 39 40 41 42 43 44 45 46

Comments to this Manuals

No comments

Goldline AQL-PS-4 User Manual Page 44

Comments to this Manuals

Related products and manuals for Above ground pool accessories Goldline AQL-PS-4